Professional plant drip irrigation installation scottsdale

Installation Process of a 1/2” Polyethylene Drip Irrigation installation

Including Valve Setup

The installation of a 1/2” polyethylene drip irrigation system begins with planning and preparation. Start by identifying the areas where irrigation is needed and mapping out the path for the tubing. Ensure that the location of the water source and main valve is convenient and accessible. Clear the designated areas of gravel to the side before trenching for clean finish. Dig trenches approximately 4-6” deep. Once the path is prepared, lay the 1/2” polyethylene tubing in the trench, ensuring it reaches all the required planting zones. Cut the tubing into sections as necessary using a sharp tubing cutter, keeping the cuts clean and precise for smooth connections.

Next, focus on installing the valve system, which serves as the control mechanism for water flow. Install a backflow preventer at the water source to ensure no contaminated water flows back into the supply. Position the valve assembly where it can be easily monitored and adjusted, then connect the polyethylene tubing to the valve regulator using appropriate fittings. Secure all connections firmly and test for leaks by briefly running water through the system.

Finally, add emitters to the tubing to distribute water directly to the plants. Punch holes in the polyethylene tubing at appropriate intervals using a specialized hole punch, ensuring the emitters are placed near the root zones of the plants for effective irrigation. Insert the emitters into the holes, ensuring they fit securely. Install end caps at the ends of the tubing after blowing out lines. Once the system is fully assembled, test it by slowly running water through and checking each emitter to verify proper function. With proper installation, your drip irrigation system will provide efficient and consistent hydration to your landscape plants.

Location: Scottsdale, AZ